Introduction
These features can be used to make a bulk change state, which can save a lot of time for the repair supervisor.
Step1: To navigate record replacement
Go to Repair module and then select Bulk state change
Step2: To add CUs
Scan the barcode or QR code of the serial numbers of the units. (Repair Supervisor has barcode scanner device)
Scanned serial numbers appear in the input field and then on the table one by one. [If not try putting the cursor on the input box first and then scan the serial number]
After a few seconds, the current state of the CU will be displayed in the records table.
Maximum 20 records can appear in the table
When the CU scanned is duplicated or more than 20 CU are scanned, an error message “ CU already scanned or maximum 20 serial numbers criteria reached” appeared
Step 3: To change the CU state to IN_REPAIR_SYSTEM
Select the “Change state in-repair” to change the New CU state from N/A to In Repair System.
You can delete a record by clicking the cross icon at the end of the row or you can delete everything by clicking on “Remove All“
0 Comments